LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Analog Instrument Panels) >> Symptom Tests >> Check Gauges Indicator Inoperative

Check Gauges Indicator Inoperative

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If Instrument Panel Cluster (IPC) diagnostic system check has been performed, go to next step. If IPC diagnostic system check has not been performed, see INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Start engine and bring to operating temperature. Observe following gauges:
    • Fuel
    • Oil Pressure
    • Coolant Temperature
    • Voltage
    If gauges are within normal operating range and not in Red areas, go to next step. If one or more gauges are operating improperly or in Red area, go to appropriate symptom diagnostic and repair procedure that best matches symptom description.
  3. Connect scan tool to DLC. Turn ignition on. Select IPC special functions on scan tool. Command CHECK GAUGES indicator on and off. If CHECK GAUGES indicator turns on and off, system is okay at this time. If CHECK GAUGES indicator does not turn on and off, go to next step.
  4. Remove instrument cluster and check indicator bulb. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION. Replace bulb as necessary and go to step  6 . If bulb is okay, go to next step.
  5. Replace instrument panel cluster. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION. After repairs, go to next step.
  6. Turn ignition off and reconnect all disconnected components and connectors. Turn ignition on. Go to INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals