LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Analog Instrument Panels) >> Removal & Installation >> Ignition Lock Cylinder >> Removal

Ignition Lock Cylinder: Removal

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Set parking brake. Remove instrument panel accessory trim plate and knee bolster panel. See INSTRUMENT PANEL ACCESSORY TRIM PLATE & KNEE BOLSTER PANEL  . Remove lock cylinder connector from retaining tab on ignition switch. Disconnect lock cylinder connector.
  2. Insert key into ignition switch. Turn ignition switch to RUN position. Using a flat-blade screwdriver, depress and hold ignition lock cylinder retaining tab located on lower right side of ignition switch. Remove ignition lock cylinder. See Figure . Note how ignition switch lock cylinder wiring is wrapped around base of ignition switch bezel for installation reference. Remove ignition switch bezel.
scientia non olet · About LEMON Manuals