Ignition Lock Cylinder: Installation
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install ignition switch bezel to lock cylinder. Insert ignition lock cylinder with key into ignition switch, and press into position until retaining tab produces an audible click. Pull on lock cylinder to ensure it is fully engaged. Turn ignition switch to LOCK position, and remove key.
- To complete installation, reverse removal procedure. Insert key into ignition switch and check freedom of movement in various positions. Attempt to remove key with ignition switch in each position. Key should only be removable when ignition switch is in LOCK position.