LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center Or Junction Block Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the RH instrument panel (IP) fuse block access opening cover.
    Fig 1: Instrument Panel Fuse Block Access Opening Cover (Right Side)
    G01737794Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the body wiring harness from the junction block.
  4. Open the IP compartment. Access the junction block bolt through the open IP compartment. Remove the junction block bolt.
  5. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the IP.
  6. Disconnect the wiring harnesses from the junction block.
  7. Remove the junction block.
    Fig 2: Junction Block
    G01737795Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals