LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal & Multifunction Switch Assembly - Disassemble - Off Vehicle

Turn Signal & Multifunction Switch Assembly - Disassemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
  3. Pop the wire harness assembly (1) out of the wire harness strap (2).
  4. Fig 1: Steering Column Wiring Harness
    G01571892Courtesy of GENERAL MOTORS CORP.
  5. Remove the small wire harness straps from the wire harness assembly (1).
  6. Disconnect the connectors of the turn signal and multifunction switch assembly.
  7. Remove the 2 pan head tapping screws from the turn signal and multifunction switch assembly. Remove the turn signal and multifunction switch assembly.
    Fig 2: Turn Signal & Multifunction Switch Assembly
    G01571893Courtesy of GENERAL MOTORS CORP.