LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Engine Exhaust System) >> Repair Instructions >> Exhaust Hanger Replacement (5.7L Engine - Right Side) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the exhaust muffler hanger and bolts.

    Tighten 

    Tighten the exhaust muffler hanger bolts to 10 N.m (89 Inch lbs).

    Fig 1: Installing Exhaust Muffler Hanger And Bolt
    G01731943Courtesy of GENERAL MOTORS CORP.
  2. Remove the exhaust pipe hanger bracket.
  3. Install the exhaust pipe hanger bracket nut.

    Tighten 

    Tighten the exhaust pipe hanger bracket nut to 20 N.m (15 ft lbs).

  4. Allow the exhaust to be support by the insulator.
  5. Remove the adjustable jack stand.
  6. Lower the vehicle.
    Fig 2: Remove Exhaust Pipe Hanger Bracket
    G01731944Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals