LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System Self-Diagnostics - 5.7L) >> Diagnostic Tests >> DTC P0336: Crankshaft Position (CKP) Sensor Performance >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Pontiac Firebird, 2000 Chevrolet Corvette, and 2000 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. After performing OBD system check, go to next step.
  2. Start and operate engine at idle for 2 minutes. Using scan tool, monitor FAILED THIS IGNITION display under DTC P0336. If scan tool indicates that this test failed this ignition, go to next step. If scan tool does not indicate that this test failed this ignition, see DIAGNOSTIC AIDS .
  3. Visually inspect CKP sensor circuits for routing too close to secondary ignition components, after-market components, solenoids, relays and motors. Repair as necessary. After repairs, go step  9. If routing is okay, go to next step.
  4. Check for poor connections/terminal tension at CKP sensor. Repair as necessary. After repairs, go to step  9. If connection or terminal tension is okay, go to next step.
  5. Check for poor CKP sensor circuit connections/terminal tension at PCM. Repair as necessary. After repairs, go to step  9. If connection or terminal tension is okay, go to next step.
  6. Remove and inspect CKP sensor. Replace CKP sensor if necessary. If CKP sensor is okay, go to next step.
  7. Visually inspect CKP sensor reluctor wheel for damage. Replace or repair reluctor wheel as necessary. If reluctor wheel is okay, go to next step.
  8. Replace CKP sensor. After replacing sensor, go to next step.
  9. Using scan tool, select DTC, CLEAR INFO function. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step  2.
  10. Using scan tool, select CAPTURE INFO, REVIEW INFO function. If any undiagnosed DTCs are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals