Removal & Installation

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Tools Required: (J-43631) Ball Joint Remover

Raise and support the vehicle. Remove the tire and wheel. Remove the rotor. Refer to REAR BRAKE ROTOR . Remove the wheel stud using the J-43631. Install a new stud. Insert the wheel stud from the back side of the wheel hub. Install 4 flat washers on the wheel stud. Install the wheel nut with the flat side toward the washers. Tighten the nut until the wheel stud is properly seated in the wheel hub flange. Remove the nut and washers. Install the rotor. Refer to REAR BRAKE ROTOR . Install the tire and wheel. Lower the vehicle.