LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Rear Suspension System) >> Repair Instructions >> Track Bar Replacement >> Installation

Track Bar Replacement: Installation

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tie rod bracket brace (4) to the body brace and tie rod bracket (3). See Figure. Loosely install the upper tie rod bolt (10) and nut (9) to the body brace and tie rod bracket (3). See Figure.
  2. Install the tie rod (5) to the body brace and tie rod bracket (3). See Figure. Loosely install the lower tie rod bolt (10) and nut (9) to the body brace and tie rod bracket (3).
  3. Install the tie rod bracket brace bolts (7) to the body brace bracket (1). See Figure. Tighten the tie rod bracket brace bolts (7) to 47 N.m (35 lb ft). Tighten the upper tie rod bolt (10) to 118 N.m (87 lb ft). See Figure. Tighten the tie rod nut (9) to 75 N.m (55 lb ft).
  4. Install the tie rod bolt (6) and nut (8) to the spring seat. See Figure. Tighten the tie rod bolt (6) to 118 N.m (87 lb ft). Tighten the tie rod nut (8) to 75 N.m (55 lb ft). Remove the rear axle support. Lower the vehicle.
scientia non olet · About LEMON Manuals