LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation

Shock Absorber Replacement: Installation

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber (6) stud to the rear axle (8). See Figure.
  2. Install the shock absorber nut (7) to rear axle. See Figure. Tighten the shock absorber nut (7) to rear axle to 90 N.m (66 lb ft). Install the shock absorber lower insulator (5) and retainer to the shock absorber (6).
  3. Position the shock absorber (6) through the underbody pan (4) and seat the insulator. See Figure. Install the shock absorber insulator (3) and retainer (2) to the shock absorber (6).
    NOTE: Turning the shock absorber while tightening the nut could damage the shock absorber. In order to prevent damage, keep the shock absorber stationary while you tighten the nut.
  4. Install the shock absorber nut (1). See Figure. Tighten the shock absorber nut (1) to 17 N.m (13 lb ft). Remove the rear axle support.
  5. Lower the vehicle. Place the folded carpet into position. Install the quarter trim panel. Fold the rear seatback into the upright position.
scientia non olet · About LEMON Manuals