LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0601-P0607, P1600, P1621, P1627, P1680, P1681, P1683 & P2610: Pcm Memory >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Is DTC P0602 set? If yes, go to next step. If no, go to step  5.
  3. Program the PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  4. Ensure that all tool connections are secure. Ensure that the programming equipment is operating correctly. Ensure that the correct software/calibration package is used. Attempt to program the PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  5. Replace PCM. See POWERTRAIN CONTROL MODULE under COMPUTERIZED ENGINE CONTROLS in REMOVAL & INSTALLATION - DEVILLE & SEVILLE article. Did you complete the replacement? If yes, go to next step.
  6. Clear the DTCs with a scan tool. Turn off the ignition for 30 seconds. Start the engine. Did the DTC fail this ignition cycle? If yes, go to step  2. If no, go to next step.
  7. Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals