TCC Brake Switch (A/T), Cruise Control Brake Switch (M/T) & BRAKELIGHT Switch
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Brake booster pushrod must be assembled to brake pedal before switches can be adjusted. With brake pedal released, switch plunger should be fully depressed against pedal shank. To adjust, depress brake pedal and push switch until switch body is fully seated on retainer. Pull brake pedal toward rear of vehicle, against pedal stop (until clicking sound cannot be heard while pulling pedal). Switch will adjust to proper position in retainer.