LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls - Removal & Installation) >> Air Induction Systems >> Throttle Body >> Removal

Throttle Body: Removal

WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove the Mass Airflow/Intake Air Temperature (MAF/IAT) sensor electrical connector. Remove the air cleaner intake duct assembly.
  2. Remove the Positive Crankcase Ventilation (PCV) valve fresh air tube. See Figure. Remove the cruise control cable from accelerator controls cable bracket. Remove the accelerator cable from accelerator controls cable bracket. Remove the cruise control cable from throttle body lever.
  3. Remove the accelerator control cable from throttle body lever. Remove the Idle Air Control (IAC) valve electrical connector. See Figure. Remove the Throttle Position (TP) sensor electrical connector. Remove the fuel feed and return lines from the retainer on the accelerator controls cable bracket.
  4. Remove the transaxle shift cable clip from the accelerator controls cable bracket. Remove the throttle body bolts from the water crossover assembly. See Figure. Remove the accelerator controls cable bracket from the throttle body, if necessary.
scientia non olet · About LEMON Manuals