LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Computer Relearn Procedures) >> General Motors (Trucks & Vans) >> Theft Deterrent System Components >> Saturn Service Stall Method (Vue)

Saturn Service Stall Method (Vue)

WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If ignition is turned off before SECURITY indicator light changes state, relearn procedure must be restarted.
  1. Check BCM and ECM/ECM for existing DTCs. If DTCs exist, repair as necessary and go to next step. If no DTCs exist, go to next step.
  2. Install scan tool. Turn ignition switch to RUN position. Using scan tool, select Passlock® relearn procedure. Wait 10 minutes. When SECURITY indicator light changes from flashing to off, or from on to off, turn ignition switch to OFF position. Vehicle should start on next ignition cycle.
scientia non olet · About LEMON Manuals