10 Minute Re-Learn Procedure (Bravada, Envoy, Envoy XL & Trailblazer)

WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When performing the 10 Minute Re-Learn Procedure, 2 master Passkey® III+ (PK3+) keys are required. If a Gray valet key is learned first, the theft deterrent control module will not allow additional keys to be learned.

NOTE: When performing the 10 Minute Re-Learn Procedure, all previously learned keys will be erased from the theft deterrent control module's memory.

NOTE: Additional keys may be learned immediately after the 10 Minute Re-Learn Procedure.

Use this procedure after replacing any of the following components:

The Passkey® III+ (PK3+) keys.
The theft deterrent control module.
The PCM.

NOTE: This procedure requires a Tech 2 scan tool and a Techline Terminal with current Service Programing System (SPS) software.

Connect the Tech 2 diagnostic scan tool to the vehicle.
With the scan tool, select Request Info. under Service Programing System and follow the scan tool on screen instructions.
Disconnect the scan tool from the vehicle and connect it to a Techline Terminal with current Service Programing System (SPS) software.
On the Techline Terminal, select Service Programming Systems and follow the Techline Terminal on screen instructions.
Disconnect the scan tool from the Techline Terminal and reconnect it to the vehicle.
With a master Passkey® III+ (PK3+) key, turn ON the ignition, with the engine OFF.
With the scan tool, select Program ECU under Service Programing System.
At this point the scan tool must remain connected for the duration of the 10 Minute Re-Learn Procedure.
Observe the SECURITY telltale or the scan tool on screen timer, after approximately 10 minutes the scan tool timer will expire and/or the telltale will turn off. The vehicle is now ready to relearn the key information and/or passwords on the next ignition switch transition from OFF to CRANK.
Turn OFF the ignition and wait 5 seconds.
With a master Passkey® III+ (PK3+) key, start the vehicle, the theft deterrent control module has now learned the key transponder information and the PCM has now learned the fuel continue password.
Turn OFF the ignition and wait 15 seconds minimum.
With a second master Passkey® III+ (PK3+) key, start the vehicle, the theft deterrent control module has now learned the second master Passkey® III+ (PK3+) key transponder information.
Learning Additional keys, if required.
With the scan tool, clear any DTCs.