LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Computer Relearn Procedures) >> CHRYSLER Corp. >> Power Sliding Door Learn Cycle (Caravan & Town & Country) >> Procedure

Power Sliding Door Learn Cycle (Caravan & Town & Country): Procedure

WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the DRBIII® scan tool to the Data Link Connector (DLC), located on lower left edge of instrument panel. Turn ignition switch to ON position. Check for power sliding door codes (fault messages). Clear any DTCs that are set.
  2. Operate power sliding door and recheck for DTCs. If any DTCs exist, diagnose and repair as necessary before performing the learn cycle. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  3. If DRBIII® scan tool is not available, the learn cycle can be performed by opening and closing the power sliding door using any of the normal open/close command switches. Be certain to cycle the sliding door through a complete open and close cycle or the procedure will not be complete.
  4. Using the DRBIII®, go into the Test Routine Menu and select a power open command.
  5. Using the DRBIII®, select a power close command.
  6. The power sliding door learn cycle is complete. If power sliding door does not fully open or close, a problem still exists. Diagnose and repair as necessary.
scientia non olet · About LEMON Manuals