Removal & Installation (5.7L)

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

Ignition system consists of 8 ignition coil/module assemblies. Each individual coil/module assembly is mounted above its respective cylinder on the rocker covers, and are attached to spark plugs using short secondary wires. Turn ignition off.
Disconnect ignition coil harness connector. Disconnect spark plug wire at ignition coil. Remove ignition coil mounting bolts. Remove ignition coil. To install, reverse removal procedure. Tighten screws to specification. See TORQUE SPECIFICATIONS .