Removal & Installation (5.7L)
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove the fuel sender assembly. See FUEL PUMP . Remove the fuel pressure regulator retaining clip. See Figure . Remove the fuel pressure regulator from the housing on the fuel return pipe.
- To install, reverse removal procedure. Inspect for leaks by using the following procedure.
- Turn ignition on for 2 seconds.
- Turn ignition off for 10 seconds.
- Turn ignition on.
- Check for fuel leaks.