Starter Motor (5.7L): Installation
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Install the starter motor shield, if necessary. See Figure .
- Lift the starter motor into position. Install the positive cable lead. See Figure
.NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the positive battery cable nut (at starter solenoid). Tighten the positive battery cable nut (at starter solenoid) to specification. See TORQUE SPECIFICATIONS
.CAUTION: Ensure the following when installing the starter lead:
- The starter lead is wrapped with heat protective tape.
- The starter lead does NOT contact the positive cable and/or connection.
- Install the wiring harness starter lead and washer. See Figure . Install the wiring harness starter lead nut. Tighten the wiring harness starter lead nut to specification. See TORQUE SPECIFICATIONS .
- Raise the starter motor to the engine block.
- Install the starter motor bolts. See Figure . Tighten the starter motor bolts to specification. See TORQUE SPECIFICATIONS .
- Install the left side catalytic converter. Lower the vehicle.
- Connect the negative battery cable. Tighten bolt to specification. See TORQUE SPECIFICATIONS .