LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Automatic Transmission Service) >> Removal & Installation >> Trim Plate >> Removal

Trim Plate: Removal

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key to the RUN position. Place the shift lever in the NEUTRAL position. Remove the shift control knob. Using a small flat-bladed screwdriver, carefully pry the staple clip from the control lever knob. See Fig 1 . Pull up to remove the knob from the transmission control. Open the console armrest door. Remove the coin holder from inside the console. See Fig 2 .
  2. Unsnap the switch plate (2) from the floor console. See Fig 3 . Disconnect the electrical connectors (4) from the switches (1, 3), if equipped. Remove the console trim plate bolts (2). See Fig 4 . Disconnect the PRNDL lamp connector. Disconnect the cigarette lighter electrical connector. Remove the console trim plate (1).
Fig 1: Removing & Installing Shifter Staple Clip
G00087650Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Coin Holder
G00087651Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Switch Plate
G00087652Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing Console Trim Plate Bolts
G00087653Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals