LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Mechanical - 5.7L) >> Removal & Installation >> Accessory Drive Belt >> Removal

Accessory Drive Belt: Removal

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Intake Air Temperature (IAT) sensor and Mass Airflow (MAF) sensor. See Fig 1.
  2. Remove the air intake duct from the throttle body and air cleaner box.
  3. Install a breaker bar with hex-head socket to the driver belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  4. Remove the belt from the pulleys and the drive belt tensioner. See Fig 2. Remove the breaker bar and socket from the drive belt tensioner bolt. Clean and inspect the belt surface of all the pulleys.
Fig 1: Disconnecting Intake Air Temperature & Mass Airflow Sensors
G98E63200Courtesy of GENERAL MOTOR CORP.
Fig 2: Identifying Accessory & Air Conditioning Belt Routing
G00005658Courtesy of GENERAL MOTOR CORP.
scientia non olet · About LEMON Manuals