Camshaft Bearing Removal
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Prior to bearing removal, inspect the camshaft bearings for loose fit in the engine block bearing bores. See INSPECTION procedure in CAMSHAFT under REMOVAL & INSTALLATION. Repair or replace the components as required.
- Select the expanding driver and washer from the tool usage information. Assemble the Camshaft Bearing Remover/Installer (J-33049). See Fig 1.
- Insert the tool through the front of the engine block and into the bearing. Tighten the expander assembly nut until snug. Push the guide cone into the front camshaft bearing to align the tool.
- Drive the bearing from the block bore. Repeat the above procedures to remove the remaining bearings.
NOTE:
To remove the front camshaft bearing, operate the tool from the rear of the block using the guide cone in the rear camshaft bearing bore.