LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Power Window System) >> Diagnostic Tests >> DTC B2206: Right Window Up Switch Fault (LDCM) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using scan tool, select LDCM input display and monitor right window status. If scan tool displays right window up status as ACTIVE, go to next step. If scan tool does not display right window up status as ACTIVE, go to step  6 .
  2. Disconnect master window switch assembly. Using scan tool, select LDCM input display and monitor right side window switch status. If scan tool display shows right window switch UP as ACTIVE, go to next step. If scan tool display shows right window switch DOWN as INACTIVE, go to step  4 .
  3. Check for short to ground in Light Blue wire between master switch assembly and LDCM. If circuit is okay, go to step  5 . If circuit is not okay, repair as necessary. Then go to step  8 .
  4. Replace master switch assembly. See WINDOW SWITCH  under REMOVAL & INSTALLATION. After repair, go to step  8 .
  5. Replace LDCM. See DOOR CONTROL MODULE (DCM)  under REMOVAL & INSTALLATION. On hardtop models, using scan tool, select RH DCM. Select DCM REPROGRAM. Follow scan tool instructions. On all models, after repair, go to step  8 .
  6. Check master switch assembly right window up circuit for intermittent malfunction. See DIAGNOSTIC AIDS  . If problem is found and repaired, go to step  8 . If no problem is found, go to next step.
  7. Turn ignition switch to OFF position. Reconnect or install any connectors or components that were disconnected or removed. Clear any DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES (DTCS)  under SELF-DIAGNOSTIC SYSTEM. Wait 20 seconds. Check for DTCs. If DTC B2206 sets as history again, go to step  5 . If DTC B2206 does not reset, system is okay.
  8. Turn ignition switch to OFF position. Reconnect or install any connectors or components that were disconnected or removed. Turn ignition switch to RUN position. Clear any DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES (DTCS)  under SELF-DIAGNOSTIC SYSTEM. Recheck system operation.
scientia non olet · About LEMON Manuals