Clutch Master Cylinder: Removal
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove driver side instrument panel insulator. Remove driver knee bolster under instrument panel. Remove clutch pedal retaining pin. Disconnect clutch master cylinder push rod from clutch pedal. Remove master cylinder attaching nuts and "U" bolt. With hydraulic line attached, remove clutch master cylinder from front of dash.
- Raise and support vehicle. Using Quick Disconnect (J-36221), depress White circular release ring on actuator hose while pulling lightly on master cylinder hose. Disconnect clutch actuator cylinder hose from clutch master cylinder hose. Protect both hose coupling ends from dirt and damage. Lower vehicle.
- Remove master cylinder reservoir push-in retainer. Slide reservoir out from hood strut bracket. Remove master cylinder and reservoir.