LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Power Door Lock System & Trunk Release) >> Removal & Installation >> Door Trim Panel >> Removal & Installation (Monte Carlo)

Removal & Installation (Monte Carlo)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place window in full down position. Remove upper door trim panel retaining screw, located at "A" pillar. Remove screws from front door pull handle. Remove inside door handle bezel screw. Remove inside door handle bezel from door trim panel. Disconnect front door lock switch harness connector. Set inside door handle bezel aside.
  2. Remove screws from upper door trim panel and pull handle. Remove screw from inside door handle bezel and remove bezel. Using Door Trim Panel Retainer Remover (J-38778), release door trim panel retainers.
  3. Support door trim panel while disconnecting harness connectors from switches. Remove door trim panel. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals