LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Overhaul >> Rear Calipers >> Reassembly

Rear Calipers: Reassembly

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper bleeder valve. See Figure . Tighten the brake caliper bleeder valve to specification. See TORQUE SPECIFICATIONS  . Install the brake caliper bleeder valve cap.
  2. Lubricate the new piston seal with Delco Supreme 11(R) GM US P/N 12377967, (Canada P/N 992667) or equivalent, DOT-3 brake fluid from a clean, sealed brake fluid container.
  3. Install the new seal into the brake caliper bore seal groove. Make sure the seal is not twisted. Lubricate the brake caliper bore and the piston with brake fluid. Install the boot and piston.
  4. Install the boot over the end of the piston so that the fold will face toward the brake caliper housing piston bore opening. Seat the boot into the brake caliper bore groove and slide the piston into the brake caliper bore. See Figure .
  5. Push down the piston to the bottom of the brake caliper bore. Make sure the boot is properly seated into the piston groove and into the groove in the brake caliper bore. See Figure . Install the brake caliper to the vehicle. See REAR BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals