LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Power Mirror System) >> Diagnostic Tests >> DTC B2232: Mirror Up Switch Fault

DTC B2232: Mirror Up Switch Fault

WARNING: This page is about a different car, the 2000 Chevrolet Corvette, 1999 Chevrolet Corvette, and 1998 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. Go to next step.
  2. Using scan tool, select LDCM input and observe mirror UP switch status. If scan tool displays ACTIVE, leave scan tool connected and go to next step. If scan tool displays INACTIVE, problem is intermittent. Check mirror down switch circuit wiring and connections. See WIRING DIAGRAMS  . If mirror down switch circuit checks okay, retest system. If DTC B2232 sets as a history code, go to step  5 .
  3. Disconnect left door switch connector. With LDCM input selected, observe mirror UP switch status. If scan tool displays ACTIVE, go to next step. If scan tool displays INACTIVE, replace power mirror switch. See POWER MIRROR SWITCH  under REMOVAL & INSTALLATION.
  4. Check for short to ground in Yellow wire between Left Door Control Module (LDCM) connector C4 terminal No. 6 and left door switch connector terminal No. 6. See Figure . See WIRING DIAGRAMS  . If Yellow wire is okay, go to next step.
  5. Replace LDCM. See DOOR CONTROL MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals