LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint Systems) >> Removal & Installation >> Sir Coil Assembly >> Installation

Sir Coil Assembly: Installation

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Center race and upper shaft assembly. Center SIR coil. Center wheels straight ahead. Center block tooth and centering mark on shaft assembly at 12 o"clock position. Install wave washer.
  2. With shaft centered, coil centered and coil aligned with horn tower, slide coil onto shaft. Install retaining ring. Check that ring seats securely in groove on shaft.
  3. Route lower coil wire along steering column jacket and install wire harness straps to steering column wire harness. Install upper and lower steering column shrouds. Install steering wheel and driver-side air bag. Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Check system for proper operation. See SYSTEM OPERATION CHECK  .
Fig 1: Removing SIR Coil Assembly
G99B00357Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals