LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint Systems) >> Removal & Installation >> Sensing & Diagnostic Module (SDM) >> Removal

Sensing & Diagnostic Module (SDM): Removal

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, See AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. SDM is located behind lower center instrument panel. Remove accessory trim plate. Remove heater and A-C control panel. Remove Connector Position Assurance (CPA) clip from Sensing and Diagnostic Module (SDM) connector and disconnect SDM harness connector from SDM.
  3. Remove mounting bolts and remove SDM from instrument panel center support. See Figure .
scientia non olet · About LEMON Manuals