LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Installation - Driver-Side

Installation - Driver-Side

WARNING: This page is about a different car, the 2000 Buick Park Avenue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the horn ground lead (2) into the lower left threaded hole in the steering wheel.
  2. Connect the horn contact lead into the steering column cam tower.
  3. Rotate the horn contact turn 1/4 turn clockwise in order to lock.
    Fig 1: Removing/Installing Steering Wheel SIR Components
    GM255209Courtesy of GENERAL MOTORS CORP.
  4. Connect the inflator module electrical connector and the CPA (4).
    5. IMPORTANT: Route the following wires correctly:
    • The driver inflator wires
    • The redundant control wires
    • The horn wires
  5. Align the driver inflator module fasteners to the steering column fastener holes.
  6. Push the driver inflator module firmly into the steering column in order to engage the fasteners.
  7. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals