LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Power Door Lock System) >> Diagnostic Tests >> DTC B2277: Right Door Lock/Mirror Heater Fault >> Testing

DTC B2277: Right Door Lock/Mirror Heater Fault: Testing

WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If power door systems diagnostic system check has been performed, go to next step. If power door systems diagnostic system check has not been performed, go to POWER DOOR SYSTEMS DIAGNOSTIC SYSTEM CHECK  .
  2. Turn ignition on. Select RDCM data list on scan tool. Operate power door locks and monitor BATTERY 2 reading. If BATTERY 2 reading does not drop more than 5 volts when door lock/unlock switch is operated, go to next step. If BATTERY 2 reading drops more than 5 volts when door lock/unlock switch is operated, go to step  4 .
  3. Monitor BATTERY 2 reading. Turn on rear defogger to activate heated mirrors. If BATTERY 2 reading does not drop more than 5 volts when door lock/unlock switch is operated, go to DIAGNOSTIC AIDS  . If BATTERY 2 reading drops more than 5 volts when door lock/unlock switch is operated, go to step  5 .
  4. Turn ignition off. Disconnect right door lock actuator connector C3. Turn ignition on. Using DVOM, measure voltage between left door lock actuator connector C3 terminals "A" (Tan wire) and "B" (Gray wire). Press right door lock/unlock switch to LOCK and UNLOCK positions. If battery voltage is not indicated, go to next step. If battery voltage is indicated, go to step  9 .
  5. Disconnect right mirror connector C1. Using DVOM, measure voltage between right mirror connector C1 terminals "B" (Black wire) and "E" (Orange wire). See Figure . Turn on rear defogger to activate heated mirrors. If battery voltage is not indicated, go to step  7 . If battery voltage is indicated, go to step  10 .
  6. Check for short to ground or short to voltage in Gray or Tan wires between RDCM and right door lock actuator. If circuit is okay, go to step  8 . If faulty circuit is found and repaired, go to step  11 .
  7. Check for short to ground or short to voltage in Orange or Black wires between RDCM and right mirror. If circuit is okay, go to next step. If faulty circuit is found and repaired, go to step  11 .
  8. Replace RDCM. See DOOR CONTROL MODULE  under REMOVAL & INSTALLATION. After repairs, go to step  11 .
  9. Replace right door lock actuator. See DOOR LOCK ACTUATOR  under REMOVAL & INSTALLATION. After repairs, go to step  11 .
  10. Replace right mirror. See POWER MIRRORS - CORVETTE article. After repairs, go to next step.
  11. Turn ignition off. Reconnect all disconnected components and connectors. Turn ignition on. Clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES  under SELF-DIAGNOSTIC SYSTEM. If DTC resets, go to step  2 . If DTC does not reset, repair is complete.
scientia non olet · About LEMON Manuals