LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Power Seat System) >> System Tests >> Test 8: Lumbar Inoperative (Passenger's Seat)

Test 8: Lumbar Inoperative (Passenger's Seat)

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If no additional symptoms are present, go to next step. If additional symptoms are present, repair other symptoms first. See SYMPTOM INDEX  table.
  2. Disconnect passenger's power seat switch connector. Connect test light between ground and power seat switch connector terminal No. 20 (Orange wire). See Figure . If test light does not come on, go to next step. If test light comes on, go to step  4 .
  3. Repair open in Orange wire between instrument panel electrical center and passenger's power seat switch. See WIRING DIAGRAMS  . After repairs, go to step  14 .
  4. Disconnect passenger's lumbar pump connector C1. Connect test light between ground and passenger's lumbar pump connector C1 terminal "K" (Orange wire). If test light does not come on, go to next step. If test light comes on, go to step  6 .
  5. Repair open or high resistance in Orange wire between instrument panel electrical center and passenger's lumbar pump. See WIRING DIAGRAMS  . After repairs, go to step  14 .
  6. Using DVOM, check for continuity between ground and passenger's lumbar pump connector C1 terminal "A" (Black wire). If continuity is not indicated, go to next step. If continuity is indicated, go to step  8 .
  7. Repair open or high resistance in Black wire between ground and passenger's lumbar pump. After repairs, go to step  14 .
  8. Reconnect passenger's power seat switch connector. Connect test light between ground and following passenger's lumbar pump connector C2 terminals while pressing lumbar switch in corresponding position. See PASSENGER'S SEAT LUMBAR TEST  table. If test light does not come on at appropriate terminal when switch is pressed, go to next step. If test light comes on at appropriate terminal when switch is pressed, go to step  12 .
    PASSENGER'S SEAT LUMBAR TEST

    Switch Position Wire Color Terminal
    Lower Lumbar Inflate Light Blue H
    Upper Lumbar Inflate Orange G
    Side Bolster Inflate Pink F
    Side Bolster Deflate Gray/Black E
    Upper Lumbar Deflate Gray D
    Lower Lumbar Deflate Yellow C
  9. Using DVOM, check continuity of inoperative circuit between passenger's power seat switch and passenger's lumbar pump. If continuity is not indicated, go to next step. If continuity is indicated, go to step  11 .
  10. Repair open or high resistance in inoperative circuit between passenger's power seat switch and passenger's lumbar pump. After repairs, go to step  14 .
  11. Replace passenger's power seat switch. See POWER SEAT SWITCH  under REMOVAL & INSTALLATION. After repairs, go to step  14 .
  12. Check passenger's lumbar pump, lines and components for damage. If inoperable or damaged components are found, repair or replace lumbar components, air bladders or air lines as necessary. See REMOVAL & INSTALLATION  . After repairs, go to step  14 . If components are okay, go to next step.
  13. Replace passenger's lumbar pump. See LUMBAR PUMP/SEAT CONTROL MODULE  under REMOVAL & INSTALLATION. After repairs, go to next step.
  14. Recheck power seat operation. If power seat operates normally, repair is complete. If power seat does not operate normally, go to step  2 .
scientia non olet · About LEMON Manuals