LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Power Seat System) >> Removal & Installation >> Seatback Cover >> Removal & Installation (Base Seat)

Removal & Installation (Base Seat)

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Remove front seat. See POWER SEAT  . Move seat to full forward position. Tilt seat back forward. Unzip seat back cover. Unhook seat back cover lower "J" strips by sliding cover sideways. Carefully slide and pull cover material out from under seat back release lever bezel. Carefully remove cover by unhooking hook and loop fasteners from foam pad. Remove the upper fasteners attaching foam pad (if removing the pad). Remove the foam pad (if necessary). To install, reverse removal procedure.

scientia non olet · About LEMON Manuals