LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Power Seat System) >> Removal & Installation >> Seat Cushion Cover >> Installation

Seat Cushion Cover: Installation

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure recliner mechanism cable retention clips are securely snapped into actuators. If draw string was not cut in removal of seat cushion cover go to next step. If draw string was cut to assist in removing a non movable seat, go to step  3 .
  2. With seat cushion cover properly positioned over foam and seat frame, tighten draw string at rear of seat and tie securely. Install hog rings attaching rear side corners of seat cushion cover. Install hog rings attaching rear center flap. To complete installation, reverse removal procedure.
  3. Remove hog rings attaching seat cushion cover rear flap. Untie draw string. Make a very small 2 in (100 mm) cut on each side of cushion cover just in front of where draw string receded when it was cut. Pull draw string out enough to securely tie ends together. With seat cushion cover properly positioned over foam and seat frame, tighten draw string at rear of seat and tie securely. Install hog rings attaching rear side corners of seat cushion cover. Wrap front seat material around draw string and hog ring material to string. Ensure no sharp points of hog rings are pointed down. Install hog rings attaching rear center flap. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals