LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Power Seat System) >> Removal & Installation >> Seat Adjuster Motors >> Removal

Seat Adjuster Motors: Removal

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front seat. See POWER SEAT  . Remove lumbar pump (if equipped). See LUMBAR PUMP/SEAT CONTROL MODULE  . Slide front motor bracket to one side, and disconnect drive cable from adjuster. Slide bracket from adjuster motor. Slide bracket in opposite direction. Disconnect drive cable and remove bracket from that adjuster motor.
  2. Position bracket outward. Disconnect harness connectors. Remove front adjuster motor. Mark location and position of rear adjuster motors for installation reference. Remove rear motors with wiring harness.
scientia non olet · About LEMON Manuals