LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Power Seat System) >> Removal & Installation >> Lumbar Bladder >> Removal

Lumbar Bladder: Removal

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front seat. See POWER SEAT  . Remove seat cushion cover. See SEAT CUSHION COVER  . Remove seatback insert pillow. See SEATBACK COVER  .
  2. Peel foam pad from side bolsters to expose lumbar system. Remove lumbar system from seat. Remove lumbar pump/seat control module "J" strips from seat support wires. Reposition lumbar pump/seat control module on seat frame. It is not necessary to remove lumbar pump/seat control module from seat.
  3. Mark hoses for upper/lower lumbar and bolster control. Cut all 3 lumbar air hoses approximately 3" (76.2 mm) from lumbar pump/seat control module. Remove tie straps attaching hoses to seat frame. Remove lumbar bladder assembly.
scientia non olet · About LEMON Manuals