Removal & Installation (1.3L, 1.8L, 1.9L, 2.2L, 2.4L, 3.5L, 4.0L, 4.6L & 5.7L)
- Disconnect negative battery cable. On 3.5L and 5.7L models, remove starter. On 4.0L and 4.6L models, remove oil filter adapter. On all models, disconnect harness connector from crankshaft position sensor. Remove crankshaft position sensor mounting bolt/nut and remove crankshaft position sensor.
- Inspect crankshaft position sensor "O" ring for wear, cracks or other damage. Replace as necessary. Lubricate NEW "O" ring with engine oil before installing. To install, reverse removal procedure. Tighten crankshaft position sensor bolt/nut to specification. See TORQUE SPECIFICATIONS .