LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Removal & Installation, Overhaul >> Ignition Systems >> Crankshaft (7X) Position Sensor (Dis) >> Removal & Installation (3.1L & 3.4L)

Removal & Installation (3.1L & 3.4L)

  1. Disconnect negative battery cable. Turn steering wheel fully to left. Raise and support vehicle. Disconnect crankshaft position sensor harness connector. Remove crankshaft position sensor mounting bolt. Remove crankshaft position sensor from engine block.
  2. Inspect crankshaft position sensor "O" ring for wear, cracks or other damage. Replace as necessary. Lubricate NEW "O" ring with engine oil before installing. To install, reverse removal procedure. Tighten crankshaft position sensor bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals