LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Removal & Installation, Overhaul >> Ignition Systems >> Crankshaft (24X) Position Sensor (Dis) >> Removal & Installation (3.1L & 3.4L)

Removal & Installation (3.1L & 3.4L)

  1. Disconnect negative battery cable. Remove serpentine belt from crankshaft pulley. Raise and support vehicle.
  2. Remove crankshaft harmonic balancer bolt. Using Balancer Remover (J-24420-B), remove harmonic balancer. Disconnect crankshaft position sensor harness connector. Remove crankshaft position sensor bolts. Remove crankshaft position sensor.
  3. To install, reverse removal procedure. Apply Thread Sealer (GM 1052080) onto threads of harmonic balancer bolt. Tighten crankshaft position sensor and harmonic balancer bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals