LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.8L V6 (VIN K) >> Removal & Installation >> Water Pump >> Removal & Installation ("F" & "W" Bodies)

Removal & Installation ("F" & "W" Bodies)

  1. Disconnect negative battery cable. Drain cooling system. Remove accessory electrical junction block, and position aside. Loosen water pump pulley bolts. Remove drive belt. Remove water pump pulley bolts and pulley.
  2. Remove power steering pump mounting bolts, and position aside. Remove water pump bolts, water pump and gasket. To install, reverse removal procedure using NEW gasket. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals