LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.8L V6 (VIN K) >> Removal & Installation >> Supercharger >> Removal

Removal & Installation: Supercharger: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE . Disconnect negative battery cable. Partially drain cooling system. Remove accessory drive belt from supercharger pulley. Remove fuel injector shield. Disconnect fuel lines from fuel rail. Disconnect vacuum hoses as necessary.
  2. Disconnect electrical connectors from fuel injectors. Remove electrical harness shield. Disconnect electrical harness from front of supercharger. Remove fuel rail and injectors as an assembly. Disconnect electrical connectors as necessary. Remove air intake duct. Disconnect EGR pipe, throttle cable, and cruise control cable from supercharger. Remove boost pressure/vacuum hose block. Remove cable bracket.
  3. Remove stud securing tensioner bracket to supercharger (use a stud remover or jam-nut procedure, if necessary). This stud must be removed to allow supercharger to clear lower intake locator pins. Remove throttle body from supercharger. Remove supercharger bolts, supercharger and gasket.
scientia non olet · About LEMON Manuals