Removal & Installation (Right)
NOTE:
Whenever right exhaust manifold pipe is removed, inspect EGR outlet pipe for leaks. If any leaks exist, replace EGR adapter.
- Disconnect negative battery cable. Remove air inlet duct. Remove throttle cable from throttle body. Remove brake booster hose. Remove serpentine belt and power steering pump bracket with hoses attached, and position aside.
- Drain cooling system. Disconnect spark plug wires and oxygen sensor. Disconnect crossover pipe and exhaust pipe from manifold. Remove transaxle dipstick tube and dipstick.
- Remove manifold heat shield (if equipped). Remove catalytic converter heat shield and pipe hanger. Remove exhaust pipe-to-manifold nuts. Remove engine lift bracket, exhaust manifold bolts, exhaust manifold and gasket. To install, reverse removal procedure using NEW gasket.