LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.8L V6 (VIN K) >> Removal & Installation >> Cylinder Head >> Removal

Cylinder Head: Removal

  1. Remove the upper and lower intake manifold. See INTAKE MANIFOLD (UPPER)  and INTAKE MANIFOLD (LOWER)  . Remove exhaust manifold. See EXHAUST MANIFOLD .
  2. On front cylinder head applications, disconnect spark plug wires. Remove engine lift bracket and rocker arm cover. Remove exhaust crossover pipe and cooling fan. Remove generator. Remove ignition coil and bracket. Remove A/C compressor bracket bolt.
  3. On rear cylinder head, disconnect spark plug wires. Remove exhaust crossover pipe. Remove power steering pump with hoses attached, and position aside. Remove heater pipe from front cover housing. Remove transaxle dipstick tube and dipstick.
  4. Remove rocker arms, push rods and guide plates. See ROCKER ARMS & PUSH RODS . Remove cylinder head bolts, and discard. Remove cylinder head and gasket.
scientia non olet · About LEMON Manuals