LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Analog Instrument Panels >> Self-Diagnostic System >> Skip Shift System Diagnostic System Check

Skip Shift System Diagnostic System Check

  1. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. If scan tool powers up, go to next step. If scan tool does not power up, perform TEST A: SCAN TOOL DOES NOT POWER UP  under SYSTEM TESTS.
  2. Turn ignition switch to RUN position. Attempt to establish communication with Powertrain Control Module (PCM). If scan tool communicates with PCM, go to next step. If scan tool does not communicate with PCM, perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS. See BODY CONTROL MODULE - CAMARO & FIREBIRD article.
  3. Using scan tool, select DISPLAY DTCs function for PCM. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, repair skip shift system by symptom. See appropriate ELECTRONIC CONTROLS article in MANUAL TRANSMISSIONS.
  4. If scan tool does not display any DTCs which begin with a "U", go to next step. If scan tool displays any DTCs which begin with a "U", perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS in BODY CONTROL MODULES - CAMARO & FIREBIRD article.
  5. If scan tool does not display DTC B1637, go to next step. If scan tool displays DTC B1637, repair generator as necessary. See appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
  6. If scan tool displays any DTCs beginning with "P", see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
scientia non olet · About LEMON Manuals