LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System With Traction Control System - BOSCH 5.3 >> Symptom Tests >> Test D: Traction Off Indicator Inoperative (Intrigue)

Test D: Traction Off Indicator Inoperative (Intrigue)

  1. Perform DIAGNOSTIC SYSTEM CHECK  under DIAGNOSIS & TESTING. Go to next step.
  2. Install scan tool. Turn ignition on, engine off. Using scan tool, observe TRACTION SWITCH parameter in Body Control Module (BCM) data list. Activate traction control switch. If TRACTION SWITCH parameter changes state, see INTERMITTENTS & POOR CONNECTIONS  under DIAGNOSIS & TESTING. If TRACTION SWITCH parameter does not change, go to next step.
  3. Turn ignition off. Disconnect traction control switch connector. Connect fused jumper between traction control switch connector terminal "E" (Brown/White wire) and ground. Turn ignition on, engine off. Using scan tool, observe TRACTION SWITCH parameter. If scan tool displays ON, go to step  5 . If scan tool does not display ON, go to next step.
  4. Check Brown/White wire (signal circuit) of traction control switch for open or high resistance. If problem was found, repair as necessary. After repairs, go to step  10 . If problem was not found, go to step  6 .
  5. Check Black wire (ground circuit) of traction control switch for open or high resistance. If problem was found, repair as necessary. After repairs, go to step  10 . If problem was not found, go to step  7 .
  6. Check BCM connector for poor connections. If problem was found, repair as necessary. After repairs, go to step  10 . If problem was not found, go to step  8 .
  7. Check traction control switch connector for poor connections. If problem was found, repair as necessary. After repairs, go to step  10 . If problem was not found, go to step  9 .
  8. Replace BCM. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. After repairs, go to step  10 .
  9. Replace traction control switch. See TRACTION CONTROL SWITCH  under REMOVAL & INSTALLATION. After repairs, go to next step.
  10. Operate system to verify repair.
scientia non olet · About LEMON Manuals