LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System With Traction Control System - BOSCH 5.3 >> Diagnostic Tests >> DTC C0710: Steering Position Signal Malfunction (Intrigue) >> Diagnosis

DTC C0710: Steering Position Signal Malfunction (Intrigue): Diagnosis

  1. Perform DIAGNOSTIC SYSTEM CHECK  under DIAGNOSIS & TESTING. Go to next step.
  2. Turn ignition off. Install scan tool. Turn ignition on, engine off. Select ABS DTC display function. If scan tool displays any DTC other than DTC C0710, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  table under DIAGNOSIS & TESTING for diagnosis. If scan tool does not display any other DTC, go to next step.
  3. Perform steering angle sensor centering procedure. See STEERING ANGLE SENSOR CENTERING  under PROGRAMMING. If centering procedure was successfully completed, go to next step. If centering procedure was not successfully completed, go to step  5 .
  4. Using scan tool, clear DTCs. Test drive vehicle. See DIAGNOSTIC TEST DRIVE  under DTC C0252: ACTIVE BRAKE CONTROL SENSORS UNCORRELATED (INTRIGUE). If DTC resets, go to step  6 . If DTC does not reset, see DIAGNOSTIC AIDS  .
  5. Replace steering angle sensor. See appropriate STEERING COLUMNS article in STEERING. After repairs, go to step  7 .
  6. Replace EBCM. See ELECTRONIC BRAKE CONTROL MODULE  under REMOVAL & INSTALLATION. After repairs, go to next step.
  7. Using scan tool, clear DTCs. Operate vehicle. If DTC does not reset, system is okay.
scientia non olet · About LEMON Manuals