LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System With Traction Control System - BOSCH 5.3 >> Diagnostic Tests >> DTC C0240: Pcm Traction Control Not Allowed >> Diagnosis

DTC C0240: Pcm Traction Control Not Allowed: Diagnosis

  1. Perform DIAGNOSTIC SYSTEM CHECK  under DIAGNOSIS & TESTING. Go to next step.
  2. Turn ignition on, engine off. Using scan tool, read any ABS/TCS DTCs. If any DTCs are set, go to appropriate DTC for diagnosis. If no other DTCs are set, go to next step.
  3. If DTC C0240 is set as a current code, go to step  5 . If DTC C0240 is not set, go to next step.
  4. Install scan tool and clear DTC. Remove scan tool. Carefully drive vehicle at speed greater than 8 MPH for several minutes. If DTC C0240 is set as a current code, go to next step. If DTC C0240 is not set, perform DIAGNOSTIC SYSTEM CHECK  under DIAGNOSIS & TESTING.
  5. Perform powertrain OBD system check. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. If vehicle passes OBD system check, go to next step. If vehicle did not pass OBD system check, perform tests recommended in self-diagnostics article.
  6. Using scan tool, clear DTCs. Operate vehicle. If DTC does not reset, system is okay.
scientia non olet · About LEMON Manuals