DTC C0197: Yaw Rate Circuit Range/Performance (Intrigue): Diagnosis
- Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING. Go to next step.
- Perform STEERING ANGLE SENSOR CENTERING procedure under PROGRAMMING. If centering procedure was completed successfully, go to next step. If centering procedure was not completed successfully, go to step 7 .
- Turn ignition off. Disconnect EBCM connector. Install Universal Pinout Box (J 39700) with Cable Adapter (J 39700-530) between EBCM and EBCM connector. Turn ignition on, engine off. Using DVOM, measure voltage between universal pinout box terminals No. 10 and No. 15 (Black/White wire). If voltage is 2.3-2.7 volts, go to next step. If voltage is not 2.3-2.7 volts, go to step 8 .
- Using DVOM, measure voltage between universal pinout box terminals No. 26 (Dark Blue wire) and No. 15 (Black/White wire). If voltage is 2.3-2.7 volts, go to next step. If voltage is not 2.3-2.7 volts, go to step 8 .
- Using scan tool, clear DTCs. Perform DIAGNOSTIC TEST DRIVE under DTC C0187: LATERAL ACCELEROMETER CIRCUIT RANGE/PERFORMANCE (INTRIGUE). If DTC resets, go to next step. If DTC does not reset, see DIAGNOSTIC AIDS .
- Replace EBCM. See ELECTRONIC BRAKE CONTROL MODULE under REMOVAL & INSTALLATION. After repairs, go to step 9 .
- Replace steering angle sensor. See appropriate STEERING COLUMNS article in STEERING. After repairs, go to step 9 .
- Replace yaw/lateral accelerometer sensor. See YAW/LATERAL ACCELEROMETER SENSOR (INTRIGUE) under REMOVAL & INSTALLATION. After repairs, go to next step.
- Using scan tool, clear DTCs. Operate vehicle. If DTC does not reset, system is okay.