DTC C0100 & DTC C0105: Rear Abs Solenoid No. 1 Or No. 2 Circuit Malfunction (CAMARO & Firebird): Diagnosis
- Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING. Go to next step.
- Using scan tool, clear DTC. Remove scan tool from DLC. Carefully drive vehicle above 8 MPH for several minutes. Turn ignition off. Install scan tool. Turn ignition on, engine off. Using scan tool in DIAGNOSTIC TROUBLE CODES, check for DTCs. If DTC resets as a current DTC, go to next step. If DTC does not reset as a current DTC, see INTERMITTENTS & POOR CONNECTIONS under DIAGNOSIS & TESTING.
- Replace EBCM. See ELECTRONIC BRAKE CONTROL MODULE under REMOVAL & INSTALLATION. After repairs, go to next step.
- Using scan tool, clear DTCs. Operate vehicle. If DTC does not reset, system is okay.