Clearing Diagnostic Trouble Codes
NOTE:
DTCs cannot be cleared by disconnecting EBCM or negative battery cable, or by turning ignition off. DTCs will be erased when ignition is cycled 100 times without fault reappearing. Ignition cycle counter in EBCM will then be reset to zero. DTCs may also be cleared using Tech 2 scan tool.
- Connect Tech 2 scan tool. Before clearing DTCs, check and note current DTC data. Select ABS/TCS function. Select DTC(S) function, and then CLEAR CODES function.
- Verify DTCs are cleared. If other DTCs are displayed, either DTCs were not cleared or ABS/TCS fault still exists. Diagnose fault and repeat procedure.